- 您现在的位置：买卖IC网 > Sheet目录219 > D2JW-01K1A1-MD (Omron Electronics Inc-EMC Div)SWITCH BASIC SPDT .1A 117GF
Precautions
Be sure to read the precautions and information common to all Snap Action and Detection Switches, contained in the Technical User’s Guide,
“Snap Action Switches, Technical Information” for correct use.
■ Protection against chemicals
Prevent the switch from coming into contact with oil and chemicals.
Otherwise, damage to or deterioration of switch materials may result.
Because the switch uses polycarbonate resin as material for its com-
ponent parts, contact OMRON if the switch material is likely to deteri-
orate due to adherence of oil or chemicals to the switch housing.
■ Soldering
To solder the lead to the terminal, apply a soldering iron rated at
30 W max. (temperature of soldering iron: 250°C max.) for no more
than 3 seconds.
Note that if soldering is not carried out under the proper conditions, there
is a danger of over-heating and subsequent heat damage.
Applying a soldering iron for more than three seconds or using one that
is rated at more than 30 W may degrade the switch characteristics.
■ Operation
Make sure that the operating body pushes the switch actuator with
an adequate force when the switch is to be operated, and that it does
not touch the actuator when the switch is released.
Install the pin plunger switch so that the operating force is applied in
alignment with the stroke of the actuator.
Do not apply excessive force to the actuator; otherwise, the switch
may be damaged.
■ Degree of Protection
The D2JW satisfies the following test condition specified by the IEC
Publication 529 (Degree of Protection by Enclosure):
Degree of protection: IP67
Test method: See the figure below.
Leave the test piece in water for 30 minutes with the top of the test
piece submerged 15 cm or more below the water level and the bot-
tom of the test piece submerged 1 m or more below the water level.
This test is to check the ingress of water into the switch enclosure
after submerging the switch in water for a given time. Note that even
if this test condition is met, the switch cannot be used in water.
■ Separator
When mounting the switch on a metallic surface, be sure to provide a
separator between the switch and the mounting plates.
Reference the following dimensions when designing the separator;
T w o, 2.4 ± 0.1 dia.
10.4
5.2
4.8 ±0.05
12
t=0.1 8
Sealed Snap Action Switch
D2JW
193
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
D2MQ-1L-105
SWITCH MINI SPDT 50MA 60GF PCB
D2MV-01L22-1C1
BASIC SWITCH
D2RV-L22E
BASIC SWITCH
D2RW01L3
SWITCH SIM LEVER SPST .25A SEAL
D2S-01L2
SUBMINIATURE BASIC SWITCH
D2SW-P01L1B
SWITCH 0.1A LEVER SPDT PC MNT
D2SW-P01L3-3M
SWITCH SIM ROLL .1A SPST-NO WIRE
D2T-LKT1-1
BASIC SWITCH
相关代理商/技术参数
D2JW01K21
制造商:Omron Electronic Components LLC 功能描述:SWIT SA NO/NC SPDT HINGE ER LVR SLDR 0.1A 30VDC 0.98N TH - Trays 制造商:Omron Electronic Components LLC 功能描述:SWITCH BASIC SPDT .1A 100GF 制造商:Omron Electronic Components LLC 功能描述:Switch Snap Action N.O./N.C. SPDT Hinge Roller Lever Solder 0.1A 30VDC 0.98N Screw Mount
D2JW-01K21
功能描述:基本/快动开关 Hinge Roller Lever Solder 100g
RoHS:否 制造商:Omron Electronics 触点形式:SPDT 执行器:Lever 电流额定值:5 A 电压额定值 AC:250 V 电压额定值 DC:30 V 功率额定值: 工作力:120 g IP 等级:IP 67 NEMA 额定值: 端接类型:Wire 安装:Panel
D2JW-01K21
制造商:Omron Electronic Components LLC 功能描述:MICROSWITCH ROLLER LEVER
D2JW01K21MD
制造商:Omron Electronic Components LLC 功能描述:SWIT SA NO/NC SPDT HINGE ER LVR WIRE LEAD 0.1A 30VDC 0.98N T - Bulk 制造商:Omron Electronic Components LLC 功能描述:SWITCH BASIC SPDT .1A 100GF 制造商:Omron Electronic Components LLC 功能描述:Switch Snap Action N.O./N.C. SPDT Hinge Roller Lever Wire Lead 0.1A 30VDC 0.98N Screw Mount
D2JW-01K21-MD
功能描述:基本/快动开关 Hinge Roller Lever Lead Wire 100g
RoHS:否 制造商:Omron Electronics 触点形式:SPDT 执行器:Lever 电流额定值:5 A 电压额定值 AC:250 V 电压额定值 DC:30 V 功率额定值: 工作力:120 g IP 等级:IP 67 NEMA 额定值: 端接类型:Wire 安装:Panel
D2JW-01K21-MD
制造商:Omron Electronic Components LLC 功能描述:MICROSWITCH ROLLER LEVER
D2JW-01K23-MAD218
制造商:OMRON Electronic Components LLC 功能描述:Sealed Ultra Subminiature Basic Switch
D2JW01K31
制造商:Omron Electronic Components LLC 功能描述:SWIT SA NO/NC SPDT SIMULATED ER LVR SLDR 0.1A 30VDC 0.95N TH - Trays 制造商:Omron Electronic Components LLC 功能描述:Switch Snap Action N.O./N.C. SPDT Simulated Roller Lever Solder 0.1A 30VDC 0.95N Screw Mount